2024 T1 Uniform Jersey Sponsor Marking Kit



MATERIAL: 100% Polyurethane

1. Place the marking kit on top of the garment in desired location. Make sure the smooth side of the film is facing up.

2. After aligning the kit position correctly, place a soft cloth or fabric on top to cover it.

3. Press on the film for 10 seconds, 3 times with an iron set to 320 degrees Fahrenheit.

4. If the kit size is too long, divide into sections and press for 10 seconds each.

5. Remove the film after cooling the heat completely, then place softer cloth or fabric on it and press it for another 10 seconds.

*If not properly attached, put the film back on and iron it slightly.

*Carefully place in desired location as it can't be removed after heating process.

*This is a transfer film specifically for clothing, so please only use on such material.

*Be careful of burns when using iron.




You may also like

Recently viewed